Bought & installed a ScanGauge D for my "new" 2001 Holiday Rambler Endeavor. Most DPs I've read about have their diagnostic port somewhere on or close to the dash. Lucky me
- mine is in the roadside electrical bay under the driver's compartment.
So after the major PIA of trying to run the cable up through the firewall
, I plug the unit in ... and it shuts down after 15-20 seconds.
Tried the troubleshooting recommendations in the ScanGauge user manual (i.e., try a different plug) ... same result.
Wondering if maybe I got the wrong connector (it was the only one I found dangling), or is there something else going on? Maybe an outdated firmware version?