Here is a helpful tool that determines details about your Ford vehicle using it's VIN number. I do hope many will find it useful.
To use this utility, simply enter in a vehicle's VIN in the box provided. The vehicle information applies to 1982 through present models only. Once the VIN has been entered, click the Submit button, and a response page will appear with that particular vehicle's VIN information.
My truck was made in Kentucky according to this Ford Fleet.com online utility.
To change this part yourself:
1. Make sure you have the correct part. This depends on the serial number of your engine which should be located on a sticker below the front of the plastic cover for the fuel bowl. Neither Ford or International calls it a "CPS", Ford calls it a CMP sensor and International calls it a CAMP sensor.
#'s: Before engine serial #375549 F6T012K073A
Serial #375549 and above F7T012K073A
#'s: Before engine serial #375549 1821720C98
Serial #375549 and above 1825899C93
2. Remove the #9 fuse under the hood (not in the dash).
3. You may want to remove the belt for easier access, but it's not necessary.
4. Disconnect the CMP sensor electrical connector. The sensor is located towards the bottom left on the front of the engine. You'll see the single wire bundle going to the sensor.
5. Remove the old CMP sensor using a 10mm socket. Be careful not to round off the bolt (there is only 1). It's on there real tight and is tough to get to.
6. Take the new CMP sensor and coat the seal with either motor oil or Vaseline and intall it. Install the bolt and reconnect the wire connector.
7. Reinstall the #9 fuse under the hood and you should be ready to go.