Hello to my WH brothers and sisters.

03HRVacationer · 01-22-2012, 05:43 AM

Hey folks, I haven't been around for a while, in a way it's a good thing no issues to be looking up. lol, Well our rig is up on the winter spot and converted to the snowmobile camp. This is our 5th year of doing this and every year I figure out better way to insulate, but this years best upgrade was using that foil insulation roll material for the front windshield, I still have my 1/2" custom ridged foam over that but what a huge difference, all my window cuts are now 1 1/2 ridged compared to the 1/2" I started out with, been using the same pieces for 3 years now, all labeled I can install it all in less than an hour, first time was a day and a half, another improvement this year was the area under the big slide, where the big gasket is, I filled that with cuts of 1.5" ridged, so it got parked here in the 3 week of November, we've had a snow drought till now but its been plenty cold, -10 to -20 isn't uncommon up here, I keep the heat on 55 when we are not here and I have a 100 gallon propane tank that starts out at 80% and I'm at 40% now, this was the first riding weekend but we've been coming up and just hanging out every other weekend, so we're doing real good compared to the first year, lol the poor heater never stopped and we didn't keep it warm when gone and went thru a full tank every two weeks, lol, my propane bill was as much as the site. So I had it perfectly level on frozen ground and they had a warm up and i'm settled so I'm heading out with the big jack to get another set of blocks under the left side tires, so I just started getting the no co on the fridge and it's a new board, do you guys think tilting this much could cause that? I'm heading over to the tech section to find the reset pin numbers again, haven't done it in a long time and want to make sure of the pin again. I good front to back it's just side to side, I know those refers are fussy and want to be level, so I'm hoping thats the issue. Any thoughts? Heading out to jack and shovel off the roof. 4 years now with the Winegard 3000 auto dish and she's still doing great. I still need to do the brake recall, I'll catchup on that thread, gotta find a place here in the NE where I won't get racked over the coals. Maxx gave me a place in Mass. Sorry for the long story, Miss you all and hope to make a WH rally this year. Peace my friends,

Al Morancy

**"007"** · 01-22-2012, 06:19 AM

Good to hear from you AL.
Had my brake recall done a Daves Trucking in Springfield, Ma. did great job re-turned all disks in 6 hours.
No co could have been a power interuption for no cooling register.
Also check the cooling coils for possible yellow substance around coils for faulty cooling unit.
You had fridge recall done ,right.
Stay warm and watch out for open ice.

03HRVacationer · 01-22-2012, 01:33 PM

Thanks Roger, I'm on it, the code is gone but we're not cooling very good, it has been working fine, all the snow on the roof was melted away around the vent. My best to you and the fam.