Resetting oil change message

jeepfreak · 07-03-2010, 06:44 PM

I know it's done by using the key on and stepping on the gas pedal a few times but I can't remember . I just spent 45 mins trying to find it in the owners manual. If its in there , were is it? Or can someone inform me? Thanks, Terry

skipwil · 07-03-2010, 07:06 PM

I owned a Geo/twn 359ts once and I think the sequence is key on and within 5 seconds pump the gas pedal 5 times- then turn key off. If not go to the W/H home page and call cust. support- have your vin ready.
driVer may know...if all else fails send him a PM
Safe Travels

edgray · 07-03-2010, 07:12 PM

with the key in on position, engine NOT running, press gas pedal to the floor 3 times within five seconds. If the reset "takes" you should see a messg on the IP flash. Turn key off and you are good to go. ED

DriVer · 07-03-2010, 07:18 PM

Quote:

Originally Posted by skipwil

I owned a Geo/twn 359ts once and I think the sequence is key on and within 5 seconds pump the gas pedal 5 times- then turn key off. If not go to the W/H home page and call cust. support- have your vin ready.

skipwil, No that's it! Key "ON" step on the gas (all the way to floor) pedal, repeatedly, 3 times within 5 seconds. The IP should flash and at this point the OLM will reset.

Cycle the Ignition to the OFF position and wait a moment and then turn the key back ON. You will observe that your OLM message will have disappeared.