Workhorse windshield wiper problems

cboh · 01-11-2005, 07:56 PM

We have an issue with our Windshield Wiper control. We have the W22 and it has a mist function, low and high settings and about 5 delays between.

The high and low settings are the same speed and the mist function does nothing. The two lower delays work.

So what I am wondering is if anyone knows where the relay is or what may be the problem with this. The wipers also stalled in the middle of the window and after about 3 min started to work again.

I checked all the nuts for tightness and they are fine.

I called the local Workhorse repair shop and they said I would have to leave it and then they would see if it was a workhorse issue or Winnebago, they said it depends if it has been altered by Winnebago?

We live in the Ventura County area of California,

Any ideas would be appreciated.

cboh · 01-11-2005, 07:56 PM

We have an issue with our Windshield Wiper control. We have the W22 and it has a mist function, low and high settings and about 5 delays between.

The high and low settings are the same speed and the mist function does nothing. The two lower delays work.

So what I am wondering is if anyone knows where the relay is or what may be the problem with this. The wipers also stalled in the middle of the window and after about 3 min started to work again.

I checked all the nuts for tightness and they are fine.

I called the local Workhorse repair shop and they said I would have to leave it and then they would see if it was a workhorse issue or Winnebago, they said it depends if it has been altered by Winnebago?

We live in the Ventura County area of California,

Any ideas would be appreciated.

**"007"** · 01-11-2005, 10:23 PM

Check the wiring plug to your wipers motor some have found excess silicon in plug causing poor plug contact connection. Clean out an use electical silicon for protection.----"007"