2000 f53 turn/brake wiring

[Ribbit]

I was told my left brake light was out on the Beast after coming to a stop light. Continued onto the campground and poked around a little. The brake/turn heads up front via a yellow wire to a connector on one of the chassis rails about 1/4 from the rear. No signal there but then the wire bundle picks up some more rear wiring, probably the right brake/turn lights, hitch wiring, gas tank sensor, etc., and dives into the box rail. Since the Beast doesn't have a drivers door and laying upside down on the engine hump is a real pain, I thought I'd ask around for the schematic of the turn signal/brake lights for the machine. I checked what Ford said was the turn signal fuse but without seeing a schematic, hopefully with connectors shown, I don't know exactly where the TS switch, fuses, and connectors are in the schematic before the wire takes off to the rear. BTW, to get it back from the campground, I plugged in a spare trailer connector, cut the bad wire heading forward and hooked the brake/turn light up to the trailer connector. Right there I know Ford/Tiffin put in two different brake/turn circuits and possibly a relay to run the trailer wiring. So, I'm looking for a partial schematic showing the complete Ford chassis TS/brake wiring from the battery to the light. Connectors would be a help. The Beast is an early 2001 33' motorhome sitting on what I assume is a 2000 Ford F53 chassis with a fire-breathing V-10. Thanks.

[subford]

I sent you a PM.