Prodigy Brake Controler

[Mtn.Mike]

I have another question for you fine people. I have a Prodigy Brake Controller with the harness for the ford truck.
Where do I plug this in. On my Chev. 3/4 ton it plugs into the fuse panel by the drivers left foot. I can't find anyplace on the Georgie Boy that is like what I see in the Chev.
I have a Georgie Boy Pursuit, 2008 on a 2007 Ford P 53 Chassis with a 7 pole plug in on the back of the coach.

Thanks, Mike

[John Hilley]

It is probably wrapped in a wire bundle on top of the steering column.

[subford]

You may need to buy one of these pigtails, most trailer sealers sell them.
You will need to wire this pigtail to the controller.
http://i54.photobucket.com/albums/g9...ector18260.jpg

Then plug the plug into the existing mating plug under the dash.
Images of the location, Steering Column, LH side (B 1) (C210):
http://i54.photobucket.com/albums/g9...trolerC210.jpg

Image of the plug:
http://i54.photobucket.com/albums/g9...d/F53/C210.jpg

/

[Mtn.Mike]

I apologize for not getting back to Subford earlier. I still have been unable to find the plug in on the wiring harness but I haven't given up.
I will probably have to remove the drivers seat to get under the dash comfortably since at 64 I'm not as agile as I used to be.
Thanks again Subford

[akcampr]

When hooking up my Prodigy to our 2007 Ford Chassis, the wiring harness was along the left side of the steering column, but had no plug on it. The wiring was labeled though.