Scan Gauge II Programming

[dwaugh10]

Does anyone have the programming sequence for transmission temp on the 6 speed transmission (2017 chassis)?

Thanks!

[Peterrrr]

Not quite sure what your looking for on Scan Gauge, but Torque's OBD2 PID editor uses the following equation for Trans Temp(221e1c)

(((signed(A)*256)+B)*(9/8)+320)/10

where signed treats the incoming values as 8 bit signed. Works on my 2017 chassis. Hope it helps.

[RV2traveler]

Have you tried the four listed on the Scan Gauge site? It should be under CANSF protocol.

https://www.scangauge.com/xgauge/for...d-temperature/

That's the first one. Scroll down that page for 3 alternates.

Alternatives #2 & #3 might be the two to start with based on what Peterrrr posted.

[dwaugh10]

Thanks. I just found it on the web today also. Haven’t tried them yet.