The Acme "EZE-TOW" Tow Dolly

[Brockx]

Originally Posted by Old Grape

They set it at 40 psi

Thank you

[thopman127]

Lifting the dolly is. To that difficult, but for me, lifting and moving it from my garage to the street proved a bit of a challenge. I installed a jack with a wheel:https://www.dropbox.com/s/kykph2khpd...2009.23.37.jpg

[Brockx]

Originally Posted by thopman127

Lifting the dolly is. To that difficult, but for me, lifting and moving it from my garage to the street proved a bit of a challenge. I installed a jack with a wheel:https://www.dropbox.com/s/kykph2khpd...2009.23.37.jpg

Just in case you did not see it.........

On my EZ tow the brake hydraulic line runs on the bottom of the center frame tube, may need to add a little spacer if yours is the same.

[thopman127]

Thanks, lots of clearance with the Reese jack. Even folds up under the stored ramps. Very satisfied.

[Brockx]

Originally Posted by thopman127

Thanks, lots of clearance with the Reese jack. Even folds up under the stored ramps. Very satisfied.

I was thinking more about the cross bolts smashing the line under the center beam. Again yours may be a little different than mine.