Community Forums

Howyduyu · 08-30-2018, 05:30 PM

I have a 2010 Newmar Ventana. I understand that Newmar used this leveling system from 2006-2010 and then stopped.
I have had this unit for approx for approx 4 months. I have taken the motors and drive all apart and have them all going up and down now with the controller.
When I use the controller and hit the Auto - to put them all down, they have been going down but the Auto level dose not always get the coach level.
How do I MANUALLY use the the control panel to finish the job of getting level.
Can they be operated individually, to tweak to each jack separately.Thanks for help very much.

mrboyer · 08-30-2018, 06:25 PM

The jacks operate in pairs so you don’t twist the chassis. You should have a manual or you can download it. Once you get level the manual has a procedure to reset the panels memory to maintain level.

MSHappyCampers · 08-31-2018, 11:49 AM

Quote:

Originally Posted by mrboyer

The jacks operate in pairs so you don’t twist the chassis. You should have a manual or you can download it. Once you get level the manual has a procedure to reset the panels memory to maintain level.

I have air leveling and don't know anything about jack leveling. If the jacks operate in pairs, how would you level if, for example, the right front wheel is in a low place compared to the other three?

mrboyer · 08-31-2018, 12:22 PM

When operating in pairs, they will level even if there is a hole for one jack. Try reading info on web sites of leveling system manufacturers to understand.

MSHappyCampers · 08-31-2018, 03:11 PM

Quote:

Originally Posted by mrboyer

When operating in pairs, they will level even if there is a hole for one jack. Try reading info on web sites of leveling system manufacturers to understand.

So you're saying that even though two jacks are operating at the same time that one of them would go lower than the other if there was a low place under it?