|
|
05-18-2016, 09:40 PM
|
#1
|
Senior Member
Winnebago Owners Club Ford Super Duty Owner
Join Date: Nov 2015
Location: Otsego, MN
Posts: 126
|
First trip up and down the hills
This is our first trip up and down the roads in the Black Hills SD. Pulling a dolly and Sable. Using the Tow-Haul our poor little V-10 was workin' it's but off! I can't even imagine what the 'real' mountains must be like!
Dan
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
05-18-2016, 09:50 PM
|
#2
|
Senior Member
Country Coach Owners Club Solo Rvers Club iRV2 No Limits Club
Join Date: May 2011
Location: Vancouver, WA
Posts: 37,725
|
Well, it'll make it but you will slow down!
__________________
2009 45' Magna 630 w/Cummins ISX 650 HP/1950 Lbs Ft, HWH Active Air
Charter Good Sam Lifetime Member, FMCA,
RV'ing since 1957, NRA Benefactor Life, towing '21 Jeep JLU Rubicon Ecodiesel
|
|
|
05-18-2016, 11:00 PM
|
#3
|
Senior Member
Join Date: Nov 2011
Posts: 884
|
Quote:
Originally Posted by Dan_S
?..our poor little V-10 was workin' it's but off! I can't even imagine what the 'real' mountains must be like!
Dan
|
What does that mean? If you mean it was revving to 4,000+ rpm climbing the grades, get used to it. It's quite normal. That's the nature of a gasoline engine. It has to rev high to develop maximum horsepower to get you up a hill.
Diesels make their horsepower at a much lower rpm, which is one reason they are quieter and last longer.
|
|
|
05-19-2016, 04:56 AM
|
#4
|
Senior Member
Thor Owners Club Ford Super Duty Owner
Join Date: Jul 2011
Posts: 3,796
|
You want that engine spinning. Not only for the power but also for the cooling. A high RPM has the water pump spinning fast moving the coolant faster thru the engine, transmission and radiator.
Don't worry about the high RPM. You can't hurt the engine with the gas pedal or gear shift. The engine computer has an electronic RPM limiter that will prevent you from taking it beyond designed limits. If it gets too hot it will start shutting down cylinders to use them as air pumps to help cool and will actually shut down everything if the temperature continues to go up.
Take your time and hang with the long haul truckers. No reason to be the first to the top of the hill, unless you come upon a herd of struggling high end DP's. Down shift manually if necessary to keep the RPM above 3500. Remember what gear you used to go up and use the same gear to keep the speed down on the other side of the mountain.
|
|
|
05-19-2016, 05:21 AM
|
#5
|
Senior Member
Winnebago Owners Club
Join Date: Nov 2014
Location: Dayton, OH
Posts: 1,136
|
Quote:
Originally Posted by Sweetbriar
Don't worry about the high RPM. You can't hurt the engine with the gas pedal or gear shift. The engine computer has an electronic RPM limiter that will prevent you from taking it beyond designed limits.
|
Agreed, but it sounds like parts are going to start poking through the engine cover.
I have not been out west with my v-10 but in the east where the grades are similar but not as long and not at high altitude I find I can top most hills at around 45 - 50 and not break 4000 rpm with good energy management. That being said the Triton V-10 is pretty bullet proof.
__________________
2007 Winnebago Journey 36SG and 13 Honda CRV Toad,
e-Trailer XHD Towbar (Demco), Blue Ox baseplate, SMI Stay N Play brakes
|
|
|
05-19-2016, 06:56 AM
|
#6
|
Senior Member
Winnebago Owners Club Ford Super Duty Owner
Join Date: Nov 2015
Location: Otsego, MN
Posts: 126
|
Thanks for the replys. This is more than just a little new to us. Have to adjust our comfort zone.
Dan
__________________
Dan & Anita
2010 Wnnebago Sightseer 33c
MN
|
|
|
05-19-2016, 07:25 AM
|
#7
|
Senior Member
Join Date: Dec 2014
Posts: 3,281
|
Quote:
Originally Posted by tim myers
Agreed, but it sounds like parts are going to start poking through the engine cover.
I have not been out west with my v-10 but in the east where the grades are similar but not as long and not at high altitude I find I can top most hills at around 45 - 50 and not break 4000 rpm with good energy management. That being said the Triton V-10 is pretty bullet proof.
|
figure about 15 -20 mph slower in a diesel pusher...
the diesel is quiter in the front... but not in the rear...
when they put the diesel in the front way noiser than the gas motor..
|
|
|
05-19-2016, 07:28 AM
|
#8
|
Senior Member
Join Date: Dec 2014
Posts: 1,666
|
From conversations with a very talented NASA engineer and VW enthusiast, one of the hard (and hard to modify) limits is the heat tolerance of the piston rings. The metallurgy of the rings has to be correct for the maximum linear speed of the piston, and the coefficient of friction between the ring and the cylinder wall. He was adamant that most piston rings in use today can endure continuous operation in the 4000-6000 RPM range. Long-stroke engines would be at the lower part of the range, and short-stroke designs at the upper end. Most people are too annoyed by the noise to run their engines this fast, but the engines can withstand much more punishment than our ears.
__________________
Mike
|
|
|
05-19-2016, 07:32 AM
|
#9
|
Senior Member
Join Date: Dec 2014
Posts: 3,281
|
Quote:
Originally Posted by Rich-n-Linda
What does that mean? If you mean it was revving to 4,000+ rpm climbing the grades, get used to it. It's quite normal. That's the nature of a gasoline engine. It has to rev high to develop maximum horsepower to get you up a hill.
Diesels make their horsepower at a much lower rpm, which is one reason they are quieter and last longer.
|
they also make way lower hp and torque, that's why they have to turbo charge them...
natural aspirated gas 6.8 motor makes more hp and torque than a 6.8 diesel motor...
a non turbo motor is way cheeper and less prone to failure,, and ways less in repairs to fix...
having the motor in the back you won't hear problems when they start, only when they finish..
|
|
|
05-19-2016, 07:33 AM
|
#10
|
Senior Member
Join Date: Dec 2014
Posts: 3,281
|
Quote:
Originally Posted by Dan_S
This is our first trip up and down the roads in the Black Hills SD. Pulling a dolly and Sable. Using the Tow-Haul our poor little V-10 was workin' it's but off! I can't even imagine what the 'real' mountains must be like!
Dan
|
do you self a favor and do the 5 star tune,, you will go up the hills faster in a higher gear...
|
|
|
05-19-2016, 07:38 AM
|
#11
|
Senior Member
Join Date: Dec 2014
Posts: 3,281
|
Quote:
Originally Posted by slowmachine
From conversations with a very talented NASA engineer and VW enthusiast, one of the hard (and hard to modify) limits is the heat tolerance of the piston rings. The metallurgy of the rings has to be correct for the maximum linear speed of the piston, and the coefficient of friction between the ring and the cylinder wall. He was adamant that most piston rings in use today can endure continuous operation in the 4000-6000 RPM range. Long-stroke engines would be at the lower part of the range, and short-stroke designs at the upper end. Most people are too annoyed by the noise to run their engines this fast, but the engines can withstand much more punishment than our ears.
|
I think the whole I can hear my engine was started by diesel pushers to justify the high cost of their rigs....do you reailize how many people change there exhaust every day so they can hear their motor run???
I remember the first thing to do with your truck was to put duals on it...
as a kid I drove front engine dragsters....to me my v 10 is quiet
|
|
|
05-19-2016, 08:46 AM
|
#12
|
Senior Member
Ford Super Duty Owner
Join Date: Sep 2014
Posts: 325
|
5 Star tune will really help.
Wish Ford would make the power stroke diesel an option on the F53 frame.
__________________
2022 Imagine 2670MK - ProPride - TV Ram 1500
2018 Isata-3 24FW - Toad 2019 Wrangler 2.0 Turbo
2015 Tiffin Allegro 36LA/Spree 323RLS/Zeppelin 281
|
|
|
05-20-2016, 07:52 AM
|
#13
|
Senior Member
Join Date: Jul 2010
Location: FT on the Road
Posts: 3,839
|
Quote:
Originally Posted by Caswelld
5 Star tune will really help.
Wish Ford would make the power stroke diesel an option on the F53 frame.
|
The FRED never caught on. Too many strikes against. Too heavy, too expensive, noise/heat factor up front is a lost benefit to why people like a DP, etc. Just my humble opinion from what I read about it.
__________________
I don't subscribe to threads I reply to so will not see your reply to my comment. Drop me a direct message if you want a reply from me.
Cheers!
|
|
|
05-20-2016, 08:35 AM
|
#14
|
Senior Member
Join Date: Jul 2012
Location: Fulltime, USA
Posts: 16,706
|
Quote:
Originally Posted by LVRVLUVR
1. figure about 15 -20 mph slower in a diesel pusher...
2. the diesel is quiter in the front... but not in the rear...
3. when they put the diesel in the front way noiser than the gas motor..
|
1. Nope
2. Nope
3. Nope
Not a DvG thread!
Back on topic: to the OP, relax and enjoy the ride. You have a fine setup and will get used to it.
Best wishes and Happy Trails
Dave and Nola, RV Mutants
|
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|