Community Forums

BoJango · 04-30-2016, 04:08 PM

I have my rig in park, the park breaks applied and the light on the touch pad for the jacks comes on when I press the button and goes off immediately when I release the button. I have shifted the selector out and into park several times along with reapplying the park breaks several times. Yet, I can't get the system to switch on.
What can you recommend I do to get my jacks working?

ChasA · 05-01-2016, 10:44 AM

Bo,
Have you tried it with the engine running? What year is your Adventurer? What brand are your jacks?

BoJango · 05-01-2016, 02:40 PM

Yes I tried it with the engine running. The batteries are all good.
The motor home is a 1996 Winnebago Adventurer. The levelers are HWH.

PapaBobby · 05-01-2016, 08:41 PM

I believe if you start the motor and put the trans in drive (with your foot on the brake) the system will enter emergency mode, which should activate the alarm and release the jacks.

Skino47 · 05-05-2016, 11:19 PM

Post #12 SOLUTION: my V10 engine team had removed all grounds on and near said failed V10 but overlooked the GROUND CABLE to my Attwood LevelLeg Controller!
Reattached ground and A-OK!
PS - My Bounder Park Brake SW will not kill levelers power but TRANS out of Park does kill all power, by design.

Thanks!!