The negative terminal stud on my onan 7500 is a bit stripped. I have it working right now but would like to fix it the correct way. Does anyone know to replace this, do I only need to remove the top cover? Was wondering if I could reach the two internal studs from the top.
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Thank you NHRA for the info and pictures. I honestly dont know if I can get the rear panel off though. It is in the front slide still and was trying to do this myself in my shop which would rather not remove the whole gen set. It looks like i just need to slide up the rear cover which i do have clearance to do that. But not completely remove the rear cover.
You'll have to remove the Top cover 1st--Remove the side bolts on both sides of the Rear cover and the bottom bolts. If You can slide the Rear cover up about 2 inches it can easily be removed, then your there.
__________________ Chuck
Brownsburg Indiana
1992 American Eagle-8.3C-450hp
That was my first thought. But with that divider between the - and + posts there isn’t enough clearance to get the die on there. Was going to thread it 1/4-20.
Linear Mode
