I am trying to adjust / align a powerglide slide and am having difficulty.
I found the slide adjustment proceedure on the powergearus.com site for the slide in my Pace arrow but am having dificulty sliding the gear over so that I can move the gear to rack engagement a couple of teeth.
Attached is the pdf for the slide alighnment. Step 2 in the proceedure is where I am having problems. The shaft will only slide maybe an 1/8" and will go not further, regardless of how hard I pry, hammer, etc. I sprayed plenty of WD-40 on the shafts and bearings and still it won't budge.
Are there any tricks to this? Am I missing something.
The trailing edge slide measures about 1/2" further out than the front slide and it causes a gap on the trailing edge when the slide is fully retracted. I want to get a good seal on the slide before we head south for the winter.