if you read my previous post you will see that my slide would start creeping out immediately after retracting it. if hydraulic pressure is causing your slide to creep out which was the cause of my slide creeping out i guess this would apply to you. hydraulics have a lot of force and will tear up anything you try to restrain the slide with if there is pressure on the system as there was on mine. it initially ripped my newly installed fitting off the floor.
the retract and extend solenoids are mounted on the HWH slide and jack pump and reservoir assembly on my moho. from the rear the retract solenoid is on the left, the extend on the right. they have a small 1/4 inch fitting in the center of the solenoid that can be loosened up to 3.5 turns to de-pressurize the slide hydraulic system.
on my moho, the jacks have solenoids also, but the release mechanism in operated by a "T" handle.
01 WINNEBAGO 35U W20.8.1L SW Wa, Hi. Good Sam, SKP. AMSOIL fluids. BANKS ecm program. SCAN GAUGE II w/ Ally temp. 2 LIFELINE GPL-6CT AGM Batts on their sides. TST tptts. K&N panel air filter. AERO mufflers. TAYLOR plug wires. ULTRA POWER track bar. KONI fsd shocks, toad '14 smart car