Slide won't go in, no power....

[RDG]

The slide out on our Georgetoen 346S will not go in. No power at switch. Is there a circut breaker? If so, where would it be located? The fuse is good so the breaker is the next thing to check out.
Thanks, Bob

[Tha_Rooster]

Ignition on, emer. brake on ?

[RDG]

The ignition and e-brake have nothing to do with the slide on this unit.

[Rbhein]

What brand slide system?

[RDG]

The leveling system is Dewalt so I belive the slide is powered by the same pump.

[Rbhein]

A faulty high pressure cutout switch will not let the pump operate. Try unplugging it.

[RDG]

Originally Posted by Rbhein

A faulty high pressure cutout switch will not let the pump operate. Try unplugging it.

Where would this be located?

[RDG]

This is what it looks like under the steps. I can not see any circut breakers.
[ATTACH][ATTACH][/ATTACH][/ATTACH]

[1mainiac]

The older Dewald systems use a reversable pump and many have a manual jack handle as well if it is a dewald S/O there will be a valve block with a valve for each room.

http://support.powergearus.com/techd...ideout_Sys.pdf

Try that pdf for info on the system.

[RDG]

[RDG]

The hyd pump that runs both the slide and the leveling system runs the leveling system OK, just the slide won't work.

Thanks 1mainiac for the system info.
Bob

[middleman210]

Ignition on mine cuts power to slide.

[RDG]

The problem was the fuse panel under the steps. Seems like a bad place to put fuses but thats where most motorhomes have them. Had to replace part of the fuse panel (the top half worked). The tech just added a new panel next to the old one and brought the 12v over to it, a few new fuses and the slide works again. The tech said water must have gotten in the panel and coroded the insides.
Bob