We have a solid surface stove top cover that is made from the same material as the counter. What I would like to do is cut it and add a hinge so you didn't have to remove it completely to use the range. Just fold it up out of the way. Has anyone done this? Will a wet saw cut the Corian material? Also, how does the hinge attach?
__________________
2005 Country Coach 40 foot Inspire 330
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Standard woodworking tools are fine for working Corian. The Corian is only one half inch thick so it might not be strong enough on the edge and might just break after you install the hinges.
__________________
2002 Fleetwood Revolution 38B
2006 Honda CR-V Air Force One
It looks like common 1/2" screws,but precision pre-drilling would be needed.
I would add epoxy glue under the hinges before putting in the screws.
Siggy
We had a foldable 2 piece Corian cover over the range in our 2001 Winnebago Adventurer. The Corian was attached to a hinged angle iron frame. The frame was hinged at the rear to the stove and also in the middle so the Corian would fit under the microwave. When the cover was opened the rear piece of Corian was slightly over the center of vertical leaning to the rear of the range. The second piece was hinged at the top of the first piece and folded downward so the Corian could be seen.
What we had worked fine. However I believe the pieces were bolted to a steel frame because the Corian was to heavy to support it's own weight. The stress of opening and closing it would have easily pulled the screws out or cracked the material.