Community Forums

Ham_Hog · 06-15-2012, 01:20 PM

Looking at the following picture can anyone tell me if this valve is on or off? I can't tell just from the orientation of the wire loop..
I haven't been able to get water going from street and can't use the water tank until I fix whats wrong with the water pump (not running plus a broken
fitting).

Thanks,
Bruce
'86 Winne Elandan

87Rockwood · 06-15-2012, 01:38 PM

Is that a push/pull valve or a 1/4 turn twist valve?

dsbike · 06-15-2012, 01:42 PM

I would say off. It appears the pointer is on the side of the valve, to be on or open it should be inline with the tubing.

Sonny & Pam · 06-15-2012, 01:55 PM

sure looks like a push/pull if so its closed as shown in photo

Ham_Hog · 06-15-2012, 02:07 PM

Tried push/pull and that is indeed what it is..thanks!

Jim_HiTek · 06-15-2012, 02:09 PM

Pull it!

Barlow46 · 06-15-2012, 02:10 PM

That was used as a low point drain valve in my 96 HR Alumalite 5th wheel. Pull to drain.

Ham_Hog · 06-15-2012, 02:55 PM

I have located 4 of these valves..one on each side of the potable water pump and another 2 through a small hatch door under the shower. The pump ones are understandable if you ever needed to replace a pump with a full tank but the other 2 could cold/hot shut off/on to the hot water heater? The diagram that winnebago emailed to me I see these 2 valves
and the drawing is abit smudged in that area to seperate the lines to see
where they go..
Bruce