Dishwasher wont start/fill

[La-Z-Boy]

Is it possible that the previous owner could have disabled the water supply to the F&P dishwasher?
There is in fact water in the line from under the sink thru the back of the cabinets to the unit, but washer won't fill after I hear the top lid close. Then I get a red blinking/beeping light
Jeff

[calhyatt]

Originally Posted by La-Z-Boy

Is it possible that the previous owner could have disabled the water supply to the F&P dishwasher?
There is in fact water in the line from under the sink thru the back of the cabinets to the unit, but washer won't fill after I hear the top lid close. Then I get a red blinking/beeping light
Jeff

My dishwasher will work if I give her a Jim Beam and diet coke. Never fails!!. Seriously, I would check the fill valve on the unit. Where the water line connects there probably is a hose type washer/filter that may be full of junk. Start there and insure that the water is in fact getting to the unit. Check that you get voltage to the fill valve solenoid. Good luck with that one. Let us know how it works out and how your troubleshooting is going...
Seeya on the road.

[dickschaak]

Originally Posted by La-Z-Boy

Is it possible that the previous owner could have disabled the water supply to the F&P dishwasher?
There is in fact water in the line from under the sink thru the back of the cabinets to the unit, but washer won't fill after I hear the top lid close. Then I get a red blinking/beeping light
Jeff

We bought a lake cabin that had not been used for a while. When we had the inspection, it would not work. When we took possession I turned it on, nothing. I after a while I decided to turn it on and leave it for a while. Sure enough after two or so minutes, it started working and has worked great ever since. Worth a try. Turn it on and leave it for a while.

[cbeierl]

Don't know about your Travel Supreme, but my Winnebago has a shutoff valve in the dishwasher supply line. You might try to trace that line to see if you have a cutoff valve on it somewhere (presumably near where it connects to the hot water supply plumbing.

[Nowabeachbum]

Our fisher paykel dishwasher was inadvertently left unlocked while traveling and after making a turn, it flew open. After that it would seem to start but then stop, beep and the light would flash. I found that one of the drawer slides had been dislodged. It wasn’t real obvious but after reseating it, everything worked fine. You might take a look at the slides to make sure they fit tight to the inside of the drawer front.
Gary

[dfwcantor]

Make sure the associated valve in the Monabloc manifod in the basement isn't turned off.

[La-Z-Boy]

The only valve in the manifold that would be related would be the kitchen sink...
And there is water there. I checked and there is water in the line under the sink that is teed off of the hot water side of the sink supply line
Hmmm...
I just wonder if there is an obstruction or another valve that I am missing
Sure cant see or get to the back of the dishwasher