|
Not sure which way you are talking about? When it's out or when it's in?
If you are talking about bringing it in tight enough to seal shut against the coach wall for driving, you need to go into the storage bay underneath the slide. Look up.
There is a piece of sheet metal held up by several screws. Remove the screws and the mechanism will be exposed. Go to the side that is "loose" and you will see a threaded rod with 2 nuts on it. Lossen the back nut, then tighten the other nut until the slide is sealed. Only caution is to make sure the slide doesn't bind coming out or going in. To do that you'll need someone to push the button inside while you watch outside and underneath the slide. Make sure you tighten the lock nut before operating the slide.
Hope this helps.
|
Linear Mode
