Community Forums

Dr. Q · 12-06-2016, 06:44 PM

Looking for a little help.... I have the MCD shades on a 2012 Anthem. All of the shades have the programming button, so I can put them into programming mode.

I have one shade, drivers side, front night shade (next the the drivers seat) that needs adjusting. I don't know of any way to adjust just that shade. I can only run all of the front shades at the same time; therefore, I don't seem to be able to just program the single shade.

Is there a way I can just run the one shade or am I missing something in the programming process?

Thanks!

Cruzer · 12-07-2016, 07:08 AM

Each shade enters its programming mode when the programming key (little black button) is pressed. I would think that if you only operated the button on that particular shade you should be able to program just that one shade, regardless of whether or not the other shades are moving. As long as you don't press the buttons on the other shades they won't enter the programming mode.

lass · 12-07-2016, 08:39 AM

This should help for setting the MCD shade limits.

Misty123 · 12-07-2016, 10:17 AM

Like mark said just put that one in programming mode, the rest will stop where they're set now. Only one you need to be concerned with is the one in programming mode.