Ride Height Specs

[Balladeer]

Looking for the Ride height spec for a 2016 Anthem 44b??????
Thanks in advance

[BFlinn181]

If it's not in your documentation, you could check with Entegra or Spartan. If you contact Spartan, have your VIN handy.

[sweetandsour]

Maybe this will help

[Balladeer]

Sweet and Sour,
This is the info I am looking for but hard to read off the forum.
Think it says Front = 9.25 inches and Rear = 8.5 inches measured from the bottom of the frame rail to the center of the axle.
Can you tell me where you found this information so that I can get a clearer copy and not make a mistake.

...Many thanks..The Balladeer

[MxChief66-1]

Ok. Call Spartan CS tell them what you need and they can email it to you same day.

[BFlinn181]

Originally Posted by MxChief66-1

Ok. Call Spartan CS tell them what you need and they can email it to you same day.

Spartan can also give you a complete build list of every component and filter used on your chassis.

[Tall Tex]

Originally Posted by Balladeer

Sweet and Sour,
This is the info I am looking for but hard to read off the forum.
Think it says Front = 9.25 inches and Rear = 8.5 inches measured from the bottom of the frame rail to the center of the axle.
Can you tell me where you found this information so that I can get a clearer copy and not make a mistake.

...Many thanks..The Balladeer

This is a copy of what Spartan sent me. Note that the front
measurement of 9.25" is the air spring height.

[sweetandsour]

This is who i spoke with at Spartan when getting specs for my front end alignment.

[Hayman]

Larry, Thanks very much for posting the ride height chart ! Copied and filed and as a DIY guy I like having this type of info on file in PRINT rather then on a disc.
Not to rant but I sure wish Spartan would offer a printed version like I had for my coach/chassis from Tiffin.

So has anyone taken the Spartan cd to Staples or the like and had a paper manual created ? If so cost ? Just curious !