RV200 Water Selector Valve

[Berlin Kid]

Originally Posted by doublebs

Anderson sent me a new cartridge over a year ago for free, no questions asked. Last summer went to Thor factory service and at my surprise they replaced the whole valve board assembly and gave me the old one. Just my 2 cents worth!

Keep the old one. I salvaged the brass bypass valve and used it to replace the plastic one.

[doublebs]

Berlin, I keep all old parts exactly for this reason.

[snevetsinc]

Originally Posted by Stiltner

Hello Everyone!

I've noticed that my water pump will prime the line, then prime (run) again for 2-3 seconds every 15 seconds or so. My first thought is the pump is sucking air. No visible signs of water or air leaking. As I start troubleshooting I can excuse the thought that it might be the Anderson Water Selector Value. I also have some air on the hot water side that I didn't have after I the line was primed. Any thoughts?

I had to replace the selector valve when it started filling the holding tank while on city water & would over flow the tank. Seems that is the common failure of the valve. It was still under warranty at the time but costs around $150. It's cheaply made with the hot water tank valve being brass but the selector switch valve being plastic, not sure why they did it that way. It's all one unit & comes with the plate & selector knobs.