ORV 21' tongue jack crank - replacement coupler fitting?

[Halifax]

Hi Friends,
I am looking for info on a replacement tongue jack crank for my 21' ORV trailer. The stock one is too long for my setup (it hits the back gate of the truck) and I would be stranded if the batteries ran down and I needed to hook or unhook the trailer. The fitting is a tube with something like a press-fit pin going through it.


Help? Tried search, which didn't get me where I wanted to go but got me sidetracked for an hour reading about other great things about our ORVs.


Thanks,
Harry

[steve52]

Have you tried the jack manufacturer's website?

[WNDOPDLR]

If all else fails, make one. Short piece of pipe drilled for a thru bolt of the same diameter as the pressed in pin. Weld a nut on the other end and use a socket and ratchet to drive.

I have one I made for my bottle jack and used a 3/4 nut so the drive was the same as my stabilizer jacks.

[brulaz]

Originally Posted by Halifax

...

and I would be stranded if the batteries ran down and I needed to hook or unhook the trailer.

...

Mine came with a crank handle for manual operation. I tried it once and it works.

[Halifax]

Originally Posted by WNDOPDLR

If all else fails, make one. Short piece of pipe drilled for a thru bolt of the same diameter as the pressed in pin. Weld a nut on the other end and use a socket and ratchet to drive.

I have one I made for my bottle jack and used a 3/4 nut so the drive was the same as my stabilizer jacks.

Thanks. The original short-handled part is an Atwood 87891 but Atwood does not make it anymore (plus they were bought by Dometic). A substitute is the Lippert 671468 but I can't find it anywhere either.


I guess I'll have to go down to the local weld shop and see what he can do. I need the short-handle to clear the truck bed, just in case...


Thanks again for the help.

[keymastr]

Here are 4 different ones. https://broadmoorrv.viaretailparts.c...s?pagenumber=3

[Halifax]

Thanks, but this is not to replace an integrated crank, but as a back-up for an electric crank. I need something like in the image. Thank you again for your helping out.