Quote:
Originally Posted by homeless
It will crank up fine but I can not move the dial on the inside. If I go on the out side I can grab hold the mass and turn it and the dial on the inside will move also. Seems to still be attached, inside to out side but I can not make the inside dial turn the mass. Is there like grease or what is my problem???
|
On the units base, near the cover over the gear should be a small, black rubber/plastic plug. You are supposed to remove the plug and spray silicone spray in the hole to lube the base plate. Reminds me, I need to do ours again.
__________________
2009 45' Magna 630 w/Cummins ISX 650 HP/1950 Lbs Ft, HWH Active Air
Charter Good Sam Lifetime Member, FMCA,
RV'ing since 1957, NRA Benefactor Life, towing '21 Jeep JLU Rubicon Ecodiesel