generac generator

[oklahomabob]

unit would run then stop. Tracked it down to fuel pump. cut hot wire and ran new wire and switch to 12 volt termanal. runs great now but when pluged into couch power nothing now power whats my problem. Thanks Bob

["007"]

May have poor 12V battery connection or fuse termination from original location or a poor ground connection.
If its running OK with your new battery connection would say your fuel pump is OK.

[rjdelapp]

Quote:

Originally Posted by oklahomabob unit would run then stop. Tracked it down to fuel pump. cut hot wire and ran new wire and switch to 12 volt termanal. runs great now but when pluged into couch power nothing now power whats my problem. Thanks Bob

If you are saying no current from generator when running that was why the fuel pump would not run after it started. If a generator is not generating current it shuts itself down which is why no power to fuel pump. Bad control board?

[garym114]

Without any model info there can be nothing specific.
Best I can do http://www.guardiangenerators.com/PublicPDFs/94468.pdf

The repair manual is specific to several models, hope one is yours.

[oklahomabob]

last week the generator was running good. Had power in coach the 110 out lets worked, microwave ect. then the generator started acting up. Would run and die in about 5 min. Hooked up a container with gas in it and ran it straight to carb. ran good, then put hose back on carb from fuel pump. Would run and die. will check voltage from generator with fuel from container. Thanks fellows for the help Bob Semper Fi

[oklahomabob]

hooked up the hot wire to the battery as i did before. Started up and ran well. Checked the voltage out of generater 2.6 volts. Now it gets wierd took off hot wire to batt that ran to fuel pump. It ran for 9 mins. to coach still no power in side. I'm going to check all connections, but i'm at a loss with out you alls help thanks Bob

["007"]

When is the last time gas filter was changed on Gen?
You may want to check the Gen wire connections in transfer switch, while your at it check them all shore power cable and load center wiring cables.
There are some Generac links in 2nd post.