Generac NP-66G Problem?

[John&Stacy]

In my 2000 Dutchstar Ford V10, I have an original 6600Watt generator that has been used once or twice for South Florida Hurricanes to power in-house appliances. Generally I ran the Genset once a month for 1/2 hour and slowly added loads and then slowly removed loads. Last time I waited 35 min. and noted all loads dumped out but genset ran. Turned everything off and next day tried system again. Loads came on ok but I noted all loads seemed to be on the same phase, not like when I used my 50 amp service and the 240v was split (2 Phase). My a/c system is split into 2 phases with an a/c on each and all other breakers evenly split. Would have thought Genset would do same, but it is one phase and the same for both sides of my a/c panel. I am now concerned this is a problem and when I use my genset can only use one a/c at a time like using 30a service at a camp ground, thus not exceeding amperage. Looking for your thoughts? Perhaps I do not have an issue, just do not know?

Tx. John

["007"]

Welcome John to irv2.
Newmar did at a time wire both AC's on same side of load center causing your problem.
If you have to much of a load the breakers on Gen may switch off.
I do not think you have a issue your aware of them.
Just check you wiring loads on both sides of your load center.
Enjoy the forums and come join us over in Newmar forum.
Just click on highlighted link below and your half there.