Hi, I was hoping to get some help on an oil leak coming from the transmission oil cooler line fitting at the radiator. I have an 07 Workhorse 8.1 with an Alllison 2100. At the radiator fitting for the upper transmission oil cooler line I have an oil leak. It does not have the jiffy tight fitting with the external clip to release the cooler line. I called Workhorse and 3 Workhorse repair centers. All have different infomation the fitting has been discontinued and no replacement at this time. W8005379 is the part number for the fitting at the radiator. Does any one know if the fitting can be removed without disturbing the the cooler inside the radiator and can the O rings be replaced and what tool is used to disconnect the line from the fitting. Thanks for any help you can provide
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Winnebago Owners Club Appalachian Campers Coastal Campers Carolina Campers
Join Date: Jul 2011
Location: North Carolina
Posts: 2,828
Glad to have you join this forum. This is a very friendly and helpful bunch of people here. Not everyone looks at the new member thread so you might have better luck posting your question under MH general discussion and problems or Workhorse further on down the page. Good luck
__________________
Brenda and Frank, FTers, Zebulon, NC
Raisin our mixed hound and BooBoo our cat.
2004 Itasca Suncruiser
Welcome to iRV2. We are glad you joined us. I also would recommend you post your question in the Workhorse Forum. There are some very knowledgeable members there that should be able to advise you.
Good Luck;
Don
__________________
Don & Bev Morgan Weyauwega WI, 05 Itasca Horizon 40KD, 400 HP Cummins, Adopted by a great couple, Toad 07 Saturn Vue AWD, Air Force One, TST 510 TPMS, Mayor of Weyauwega 2007 - 2013, Waupaca Co Board Supervisor 2010 - 2014
Glad to have you join this forum. This is a very friendly and helpful bunch of people here. Not everyone looks at the new member thread so you might have better luck posting your question under MH general discussion and problems or Workhorse further on down the page. Good luck
Linear Mode
