Entrance Door Window Replacement

[BillR38701]

I have a 1997 Vectra, WCM34WQ. My nephew was cutting the glass and yes a rock broke the window in the entrance door. I want to replace the glass but can't figure out how to do it. I pulled the inner frame out but the outter side did not come out. Does anyone know what I have to do?

[BillR38701]

I have a 1997 Vectra, WCM34WQ. My nephew was cutting the glass and yes a rock broke the window in the entrance door. I want to replace the glass but can't figure out how to do it. I pulled the inner frame out but the outter side did not come out. Does anyone know what I have to do?

[Diplomat Don]

Bill.....If it is like most, you remove the inner plastic panel and the outer is usually stuck on with putty. If you can leave it in place and get to the glass, I wouldn't remove the outer unless it's time for new caulking. You might think about replacing the glass with plexiglass.

Good Luck

[BillR38701]

I removed the frame on the inside of the door, but apparently I have to remove the inner part of the window. I am not sure how to do it. Two things that look like screws come up into the inner part from below it. Any suggestions?

[RV Wizard]

The frame is revited together at the seam. If you are trying to replace just the glass you will need to open the frame up.

[BillR38701]

RV how do you get the inner frame out of the door to get to where the glass goes? Any idea?