|
|
12-23-2012, 08:26 PM
|
#15
|
Moderator Emeritus
Nor'easters Club Workhorse Chassis Owner iRV2 No Limits Club
Join Date: Oct 2004
Posts: 30,785
|
Is your battery cut off switch on so charger can charge your batteries?
Here is another battery related problem others have been having.
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
12-23-2012, 09:08 PM
|
#16
|
Senior Member
Workhorse Chassis Owner
Join Date: May 2009
Location: Kansas City, MO./Pollock, LA.
Posts: 1,556
|
Read your Inverter monitor again. It says AC in, it says "Normal" and your voltage is 14 volts.
The three pictures of the battery are low, normal, and full from left to right. On my panel it is written low, normal ,and full.
Your good.
I think the white panel is for satellite, it displays elevation or azimuth.
__________________
06 Hurricane 34FT WH W20 Chassis 8.1L 132K, Steersafe, Koni Shocks, DIY Trac Bar, Tri-Metric 2025RV Battery Monitor, 4-6V Batteries, Scan Gauge 2, Crossfires, 735W Solar Morningstar MPPT-60, WG T4 In-Motion Sat, XM Radio, 07 Chevy Malibu Maxx Toad, Falcon 2, Brake Buddy, Escapee
|
|
|
12-23-2012, 09:47 PM
|
#17
|
Senior Member
Join Date: Jun 2011
Location: FL
Posts: 11,452
|
After zooming in very closely it appears you may have the charger off. Did you get any manuals with this rv? I downloaded one that leads me to believe you don't have the buttons pressed/setup properly. Looking closely I noticed you have a "level" indicator on the left panel if you press the "test" button.
In any case I am going to attach a close match manual. Go to page 25 section 3.
__________________
Certified Senior Electronic Technician, Telecommunications Engineer, Telecommunications repair Service Center Owner, Original owner HR 2008
.
|
|
|
12-24-2012, 07:00 AM
|
#18
|
Senior Member
Workhorse Chassis Owner
Join Date: May 2009
Location: Kansas City, MO./Pollock, LA.
Posts: 1,556
|
Push the "charge' button, see if the LED above the word "charge" lights.
__________________
06 Hurricane 34FT WH W20 Chassis 8.1L 132K, Steersafe, Koni Shocks, DIY Trac Bar, Tri-Metric 2025RV Battery Monitor, 4-6V Batteries, Scan Gauge 2, Crossfires, 735W Solar Morningstar MPPT-60, WG T4 In-Motion Sat, XM Radio, 07 Chevy Malibu Maxx Toad, Falcon 2, Brake Buddy, Escapee
|
|
|
12-24-2012, 07:05 AM
|
#19
|
Senior Member
Workhorse Chassis Owner
Join Date: May 2009
Location: Kansas City, MO./Pollock, LA.
Posts: 1,556
|
Try this manual
__________________
06 Hurricane 34FT WH W20 Chassis 8.1L 132K, Steersafe, Koni Shocks, DIY Trac Bar, Tri-Metric 2025RV Battery Monitor, 4-6V Batteries, Scan Gauge 2, Crossfires, 735W Solar Morningstar MPPT-60, WG T4 In-Motion Sat, XM Radio, 07 Chevy Malibu Maxx Toad, Falcon 2, Brake Buddy, Escapee
|
|
|
12-24-2012, 07:12 AM
|
#20
|
Senior Member
Join Date: Dec 2011
Location: Corinth, MS
Posts: 485
|
The manual I looked at shows a lighted indicator on the top left corner of the charge button and a lighted indicator on the main unit also on the top left corner, it just may be as simple as its not turned on, I also dont see your power share selected to 30 amps, http://www.xantrex.com/documents/Inv...-01_rev-2).pdf or look at this manual and determine what unit you have, The light on the control may be out or not on that model?
__________________
Mike & Becky
2005 Holiday Rambler Navigator 45PBQ
|
|
|
12-24-2012, 09:34 AM
|
#21
|
Senior Member
Join Date: Jun 2011
Location: FL
Posts: 11,452
|
Glad the exact model manual is posted. That should clear things up quickly. Those smart chargers can be quite amazing and seemingly complicated.
__________________
Certified Senior Electronic Technician, Telecommunications Engineer, Telecommunications repair Service Center Owner, Original owner HR 2008
.
|
|
|
12-24-2012, 11:13 AM
|
#22
|
Senior Member
Monaco Owners Club
Join Date: Sep 2012
Location: Titusville Fl
Posts: 266
|
As an update the control panel this morning showed that the batteries now have a full charge as I thought they should.
I got busy doing other projects and almost forgot to update you guys.Thanks for the help and advice.
__________________
Dan & Kris Murphy
2022 Newmar Baystar 3226
2020 Chev Equinox 2.0
|
|
|
12-24-2012, 11:51 AM
|
#23
|
Senior Member
Join Date: May 2011
Posts: 967
|
For what it is worth.....here is how my Xantrex panel looks and everything is A-OK with my system. Your "charge" light (led) should be on (just press it) and you should also be getting a reading on your incoming AC Breaker Amps (POWER SHARE) gauge.....
Before you plug into an external AC source note the breaker size & press POWER SHARE until the the appropriate INCOMING AC BREAKER LED is ON. POWER SHARE limits the amount of external AC current used by the charger.....by selecting a lower POWER SHARE setting it will take longer for your batteries to become fully charged.
Note... Available POWER SHARE setting vary from inverter/charger model & only the settings that the charger supports will be allowed.
Hope this helps?
__________________
Jack & Maggie
04-Rexhall Roseair (37)
Cummins ISC / Spartan
|
|
|
12-24-2012, 12:49 PM
|
#24
|
Senior Member
Monaco Owners Club
Join Date: Sep 2012
Location: Titusville Fl
Posts: 266
|
Thanks Jack, that is good info!
__________________
Dan & Kris Murphy
2022 Newmar Baystar 3226
2020 Chev Equinox 2.0
|
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|