Onan Starting

[john60]

I need help! I have a 1995 Onan NHE-K that will not continue to run after the start switch is released and related the fuel pump is not getting any power. I have checked the oil pressure switch, the brushes are free. What is the best way to test for output voltage when cranking? I am down to a bad control board or a bad voltage regulator. Does anyone have any ideas? Thanks in advance.
John60

[john60]

I need help! I have a 1995 Onan NHE-K that will not continue to run after the start switch is released and related the fuel pump is not getting any power. I have checked the oil pressure switch, the brushes are free. What is the best way to test for output voltage when cranking? I am down to a bad control board or a bad voltage regulator. Does anyone have any ideas? Thanks in advance.
John60

[Hitchhiker]

John,

Welcome to iRV2, it's great to have you here as a new member. I'm sorry you're having problems with your generator, maybe this link to an Onan Generator Troubleshooting page will help.

Again, welcome to iRV2!

[john60]

Thanks HitchHiker, the link gives me some specifics to troubleshoot
John

John & Barb
Two Shih-tzus Misha and Meilee
1995 Newmar Mountain Aire 38'
1999 Jeep Cherokee toad
KCOEXS
Longmont, Co

[Renegades]

John,
Replace the control board. If you hold the start switch in and the generator continues to run and put out voltage, you have a bad control board. That is what usually goes first. If it continues to run and you get no voltage out, replace the voltage regulator. Good Luck.