Pressure Pro Monitors on DOT Capless Stems?

[JavaJelly]

Due to HUGE problems w/valve stem extensions last year, I had DOT caps put on the valve stems. They allow for the checking of pressure and inflation by just pushing a straight guage on the end.

Wondering if the Pressure Pro sensor will work with that end? I will be installing PP tomorrow.

Of course I will check w/Manuacturer but, wondered if there was any experience out there.

Thanks.

[JavaJelly]

Due to HUGE problems w/valve stem extensions last year, I had DOT caps put on the valve stems. They allow for the checking of pressure and inflation by just pushing a straight guage on the end.

Wondering if the Pressure Pro sensor will work with that end? I will be installing PP tomorrow.

Of course I will check w/Manuacturer but, wondered if there was any experience out there.

Thanks.

[Ecker]

<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by JavaJelly:
.

Wondering if the Pressure Pro sensor will work with that end? I will be installing PP tomorrow.

Of course I will check w/Manuacturer but, wondered if there was any experience out there.

Thanks. </div></BLOCKQUOTE>

I had the same arrangement when I installed the PP some years ago and they would not work. I called AdvantagePP before doing and they had no information at that time. I suppose now that some years have gone by they will be more informed.