Sealevel tank Monitor sys

[jj1457]

I have a 2002 Winnebago Journey Dl 36'
I'm going to try putting in a Sealevel tank Monitoring sys. I don't have any trouble with the Gray or Black tanks. How do I get to the freash water tank?

[jj1457]

found it. remove panel behind the water tank. 8 or 10 screws by the drain outlet. Remove panel and there is your wiring and water tank. Not much room to work in but it can be done.

[Lukeaa]

On my See-Level system, I ended up moving the sensor strips several times, before I was happy with the accuracy of the readings they gave. Be sure and stick them on with duct tape until you are happy with your readings. I also had one sensor that was defective, so it was easy to replace when See-Level sent me a new one.

[Joe-K]

Since you have 2002 Journey 36G, you might want to glance over the following thread. I had the exact same motorhome and took pictures throughout the installation which might give you some ideas.

Check it out if you'd like
SeeLevel Guage System in Winnebago

[jj1457]

Thanks for the information Joe. I saved it on my computer so I can review it while i'm installing my system.

[smlranger]

I also installed the See Level system on my '02 36DL and have been pleased with its reliability. The fresh water tank was not so easy but do-able. Part of the sensor can be installed on the front of the tank while the other section may need to be installed on the side. Access to the side of the tank is via the passenger side compartment.

Let us know how it goes.

[jj1457]

Thanks for the info. I'm retired AF 1980 Sounds like you are too.