Two Piece Shower Separating

[Craig P.]

Unfortunately, my MH did came equipped with a two piece shower stall. A small section of the seam where the two pieces meet is starting to separate. Reaching into the seam with my finger, I can tell that they were secured together with nothing more than double sided foam tape. This doesn’t seem like a very smart way to keep things secure and water-tight.

I’d like to separate the seam all the way around and re-secure or glue it back together with something a little more permanent, but I’m not sure what to use.

Any suggestions?

Craig

[ahicks]

Whatever you do, the installation MUST allow the plastic to expand/contract with temp changes. Cracking guaranteed if that's not possible. Not sure glue would be a good plan, but something different in the way of double sided tape may be a good one?