Many threads have been published on this topic. Here is one more and I hope it helps someone.
As stated in several threads, the 7.5A fuse to be removed, per Honda, is in a bear of a location. Too boot, it is a low profile type
, hard to get out and near impossible to reinstall without loosing it (as i did
) in the hole under the fuse box.
The following pictures are of my solution. I used a standard profile fuse. Drilled to receive 2 8mm screws, pulled the fuse legs out of the housing to cut the fuse link, attached 2 stakeon eye terminals under the screws and filled the space between the fuse legs and the area between the screws with epoxy for strength and stability. The fused leg wire went to the + terminal of the sw and the ground of the sw was attached to a bolt in the car console, behind the panel used for the sw.
One ATM fuse
2 8mm brass wood screws
2 small #6 or #8) ring stakeon terminals
3 spade stakeon female terminals
1 ground ring stakeon
3 colors of wire (white, black, blue for instance)
1 in-line ATM fuse holder
1 7.5A ATM fuse
Single pole single throw switch