I finally started the install of my new SMI in my Jeep. Got the duo installed today, started by removing the "platform" on the drivers side and fabricated an aluminum plate to replace it so the duo will sit flush. Countersunk the bolts to the aluminum plate to the bracket and then self tapped the duo to the platform.........see attached photos. Tomorrow we will be back at it and finish up the install of the gforce controller, brake switch, breakaway, and all the wiring.
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Finished up the install yesterday. Test drive went well, I rode in the jeep while a friend drove the MH. Brakes great eases on and off no jerking, I will do some fine adjustments to the sensitivity.
I need to make some detailed checklists for the jeep setup and the SMI to Tow.