Go Back   iRV2 Forums > MOTORHOME FORUMS > Class C Motorhome Discussions
Click Here to Login
Join iRV2 Today

Mission Statement: Supporting thoughtful exchange of knowledge, values and experience among RV enthusiasts.
Reply
  This discussion is proudly sponsored by:
Please support our sponsors and let them know you heard about their products on iRV2
 
Thread Tools Search this Thread Display Modes
 
Old 07-10-2014, 06:08 PM   #1
Junior Member
 
Join Date: Apr 2012
Location: Anywhere USA
Posts: 8
Screws backing out of floor

I'm looking to buy a new Jayco "Greyhawk" 29 MV Class C motorhome. I have looked at about half a dozen of these coaches and all them have numerous bumps in the vinyl flooring from the screws backing out of the floor. I even looked in a new Jayco "Percept" Class A motorhome in the lot and this too has the same problem. Has anyone out there seen this before? Previously I had a Newmar Baystar (purchased new in 2012) with the same issue which, after much grief, Newmar replaced the whole floor. Is this typical to motorhomes? Any help would be appreciated. I don't want to make another costly mistake. Many thanks.
__________________

__________________
freerollr is offline   Reply With Quote
Join the #1 RV Forum Today - It's Totally Free!

iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!

You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!

Old 07-10-2014, 09:01 PM   #2
PGD
Member
 
Join Date: Jan 2014
Location: Toronto, ON
Posts: 50
I have a Jayco 31fs that I bought in November. I haven't noticed any issue with the floor.
__________________

__________________
PGD is offline   Reply With Quote
Old 07-11-2014, 08:39 AM   #3
Senior Member
 
Join Date: Jul 2011
Location: Hawkeye State
Posts: 143
haven't seen any issues on my Greyhawk 31SS
__________________
2011 Jayco 31SS V10
2006 Ranger Reata 1850
2014 Jeep Grand Cherokee 4-down
Gma-n-Gpa is offline   Reply With Quote
Old 07-11-2014, 09:10 AM   #4
Senior Member
 
Davinger's Avatar
 
Ford Super Duty Owner
Join Date: Aug 2011
Location: Cocoa Beach Fl.
Posts: 257
Send a message via Yahoo to Davinger
I have a 2011 Greyhawk 31FS no issues like that.
__________________
Davinger is offline   Reply With Quote
Old 07-11-2014, 09:57 AM   #5
Junior Member
 
Join Date: Apr 2012
Location: Anywhere USA
Posts: 8
Screws backing out of floor.

Thank you all for your reply.
__________________
freerollr is offline   Reply With Quote
Old 07-22-2014, 09:05 PM   #6
Member
 
Sunshine23's Avatar
 
Join Date: Jul 2014
Posts: 51
We recently had a 2011 Greyhawk 31fs and we did not experience that issue either.
__________________
Sunshine23 is offline   Reply With Quote
Old 07-26-2014, 08:21 AM   #7
Member
 
short kid's Avatar
 
Join Date: Oct 2013
Location: Poconos, PA.
Posts: 81
We have a 2014 Greyhawk and it will be going in to the shop for that very reason. I noticed them in the hallway and bathroom. When I got under the coach to look I could not see anything because the screws go into a square tube cross member. Our coach only has a little over 3k miles on it.
__________________
short kid is offline   Reply With Quote
Old 08-21-2014, 05:07 PM   #8
Member
 
NC Roamer's Avatar
 
Ford Super Duty Owner
Join Date: Aug 2014
Location: Fuquay-Varina, NC
Posts: 34
We test drove a 2014 Greyhawk 31FK day before yesterday. We liked it and told the local Jayco dealer that we'd take it.

Our official PDI is next Tuesday, but we did go ahead and tell them a couple of things that we had already noticed. One was a bump in the vinyl flooring where a screw wasn't completely in. The salesman noted it on our purchase agreement and said the service department would take care of it before our PDI. We saw only that one raised screw, and we looked very carefully at the entire floor after seeing it.
__________________

__________________
NC Roamer is offline   Reply With Quote
Reply

Tags
scr



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Fleetwood Introduces New Floor Plan for Discovery DriVer RV Industry Press 0 06-13-2014 01:56 PM
Screws loose on ladder Graeagle55 Monaco Owner's Forum 6 06-13-2014 08:11 AM
1972 Vw lil bugger- need serious advice. Floor sag. Thenoob Vintage RV's 22 04-29-2014 08:23 AM
Floor in forward slide on a 05 KS 3720 AtlantaRick Newmar Owner's Forum 8 04-08-2014 09:45 AM
Screws into fiberglass PGD iRV2.com General Discussion 5 03-25-2014 06:55 PM

» Virginia Campgrounds

Reviews provided by


Copyright 2002- Social Knowledge, LLC All Rights Reserved.

All times are GMT -6. The time now is 03:50 AM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2017, vBulletin Solutions, Inc.