RV Trip Planning Discussions

Go Back   iRV2 Forums > mel s
Click Here to Login
Join iRV2 Today

Mission Statement: Supporting thoughtful exchange of knowledge, values and experience among RV enthusiasts.
Conversation Between mel s and 1ciderdog
Showing Profile Comments 1 to 2 of 2
  1. mel s
    10-25-2012 10:25 AM
    mel s
    Thanks
    I ues the J1708 end of the SGD plug/cord so J1708 is the setting I used.
    Since reading your suggestion I changed the SGD setting to J1939.... the Boost reading is still about 2X what it should be, although everything else seems work correctly on either setting, (Except for the Trans Fluid Temp, which works on neither)!
    SGD has asked me to check my boost at idle, in both settings, and report to them so they can figure out the problem and find a cure.
    Mel Stuplich
  2. 1ciderdog
    On my scangauge I had to select the more button a couple of times and it comes up with both or J??8 or J??9. It was initially on both. I changed it to the number ending in 9 and boost is now more realistic - up to about 28 -29 on a pull. This suggestion was made to me by scangauge after I sent them an email describing the problem. You might give that a try and if need be I'll go out to the RV and do the process again so I can accurately describe the process.
    Good luck
    Bob

Copyright 2002- Social Knowledge, LLC All Rights Reserved.

All times are GMT -6. The time now is 06:42 PM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2018, vBulletin Solutions, Inc.