RV Trip Planning Discussions

Go Back   iRV2 Forums > Members List
Click Here to Login

Join iRV2 Today

Mission Statement: Supporting thoughtful exchange of knowledge, values and experience among RV enthusiasts.
Rorytug is on a distinguished road

Rorytug Rorytug is offline

Senior Member

Profile Comments

Showing Profile Comments 1 to 1 of 1
  1. David K
    05-28-2013 07:06 PM
    David K
    I don't recall the exact size but, I used a drill bit just a little bigger than the center of the rivet so I would just cut the holding edge of the rivet. After cutting the holding edge, I punched the rivet on inside the door (it does rattle when opening and closing the door but, no way to remove). I think the rivet itself was 1/8th inch and was about 3/8" long -- I used one that was long enough to go through the new latch and go inside of the door metal a little -- the door metal is not that thick as I recall -- hope this helps.

About Me

  • About Rorytug
    Las Vegas
    State or Province
    RV Manufacturer
    RV Model
    RV Length
  • Signature
    2011 Itasca Sunova 33C, 2001 Acura MDX, DW and her 2 Barbiedogs


Total Posts
Profile Comments
General Information
  • Last Activity: Yesterday 09:14 PM
  • Join Date: 05-23-2013
  • Referrals: 0

Copyright 2002- Social Knowledge, LLC All Rights Reserved.

All times are GMT -6. The time now is 07:14 AM.

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2019, vBulletin Solutions, Inc.