RV WizardModerator Emeritus |
Last Activity: 03-07-2020 05:18 AM
- User Lists
Profile Comments
Showing Profile Comments 11 to 20 of 45
-
07-24-2015 04:59 AMtourdasouthI have a 2006 winnebego tour fd. The circuit that is connected to the inverter ( entertainment center / wall outlets etc.) have no 110 power. Using a volt meter, I have tested the inverter control panel circuit breakers, the load center breaker, the inverter 30 amp reset breaker and the power going in and out of the inverter. all test ok. still no power to the outlets. any help would be appreciated.
-
02-28-2015 11:00 AMChris TravelsHello,
I recently became a distributer for Progressive Industries and can offer a 10% discount to members. How can I post this to the deals and promotions forum?
Chris -
04-09-2014 08:08 AMspritzSir Can you help me? Please
Originally Posted by spritz
I have a American Industry's water heater I am trying to see if there is a rod in the tank that needs to be replaced I think its a anoid Rod? Do I remove the drain plug and try taking that out and see it? Maybe they don't have one I am not sure the manual doesn't say anything about one????
Thanks for your wisdom...
Tim -
04-09-2013 12:51 PMscenic 8406sorry we missed ur bd. ive had a scenic cruiser model 8406 on a k-2 chassie.engine is a ism5oo with a allision md4060 trans.we love this coach its been a real workhorse.we pull a pace utra 26 12000lb trailer.tows well.we pull a 05 element when were not taking care of family on east coast.its good to see these mhs still going great.i guess my question is have u run across any of these coaches before?
-
04-02-2013 01:50 PMJC2Happy birthday Mike. Thanks for all your past help.
-
03-06-2013 07:58 AMGranitemanHello Mike,
I have a slide roller on my front kitchen slide that is loosing the protective orance (rubber?) coating. I was able to remove the baseboard on the cabinets but it appears that the slide will need top be unbolted and allowed to drop outside so that the inside will raise enough to allow access. I have lots of cribbing, jacks and forklifts. Can this be done the way I am considering or are there components that I am unaware of? I was hoping with the similar years and models of our coaces and your experience you may be able to offer some advice.
Thanks,
Travis -
02-20-2013 11:34 AMCruisn BobThanks for response. I will get to know more about you later. The rig I'm looking at is a DP. I looked at that ad on your profile from Sprads. Tooo bad it only had a 300
-
01-28-2013 07:35 AMDogpatchHi Mike, Thanks.
Do you mind me asking what the cost was? -
01-27-2013 10:42 AMDogpatchI forgot to mention this is the exact engine CUMMINS 6C 8.3 330hp ISC Turbo Diesel.