iRV2 Forums

iRV2 Forums (
-   Class A Motorhome Discussions (
-   -   Slideout and Leveling jacks not working (

flogra57 09-20-2019 05:49 PM

Slideout and Leveling jacks not working
New to the group and hope I am doing this correctly.
I have a 2007 Fleetwood Fiesta (model 34N) and slideouts and jacks stop working. Both was working one day and not working the next day. Are they on the same circuit? Is there a relay, fuse or circuit breakers that I can check?

MSHappyCampers 09-20-2019 05:51 PM

Hi ! Welcome to IRV2! We're sure glad you joined the gang! :dance:

I'm not a Fleetwood guy so can't answer that. I would look for a blown 12VDC fuse!

Good luck, happy trails, and God bless! :thumb::D

PJStough 09-20-2019 06:05 PM

What company makes your slides and jacks? HWH, Power gear, or other?

A Traveler 09-20-2019 07:39 PM

Need a LOT more information. Are they electric/mechanical or hydraulic?

navychaps 09-20-2019 07:46 PM

Make sure park brake is set.

flogra57 09-21-2019 12:18 PM

I have checked all fuses, replaced the circuit breakers they Fleetwood said was associated with the slideouts and nothing. The slideouts and jacks are electrical. Manufacturer is PowerGear. (2007 Fiesta by Fleetwood)

Stan&Jacquie 09-21-2019 10:33 PM

I recently had a similar problem with my hydraulic jacks and found it to be a bad ground. If you have 12 v to the pump then don't assume the pump is bad without checking the ground first. If it is ground then the repair is rather simple.

dmevis 09-22-2019 06:18 PM

You didn't provide much information about the problem. Not even any sound when you try to activate them? Or sound, but nothing really happens?

On my newly acquired 2007 RV, my jacks were really a problem. Found that the hydraulic resevour was empty. It took a while after filling it with hydraulic fluid to get all of the air out of the hydraulic lines.

Jthigh 09-22-2019 07:01 PM

Leveling jacks are probably operated by hydraulic pump via electric motor. Slides could be similar or straight electric. Need to check hydraulic fluid levels and listen to pumps and/or motors if they try to engage or not. This will lead you to either a hydraulic or electric issue. My jacks only operate with the ignition key in the ACC position. I have a power gear system as well although a lot older. Maybe yours is powered similar.

All times are GMT -6. The time now is 07:51 PM.

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2019, vBulletin Solutions, Inc.