Attaching the back splash
rjhorton:
Yesterday it became necessary to remove part of the back splash to get at some wiring to install a new remote panel for our inverter/charger. It was suggested that a couple of dabs of silicone on the center of the back surface and a couple of dabs of hot glue at the ends of the back surface would hold it. If you can leave a little space with tooth picks on the bottom edge so you can add caulk later. The hot glue will hold the back splash while the silicone takes some time to set. I finished the bottom edges with the DAP Kwik Seal Kitchen & Bath Adhesive Caulk. The colors available are biscuit, almond and white.
Caution: The #$%@?!! hot glue gun works well but will really blister ones integument . So handle with care.
My .02.
Milt
__________________
Joyce, Milt 2000 Safari Trek 2830
Kettle Falls, Wa
|