HWH jack screw leak!!

[Tenn.Vol.]

Today I raised the MH to grease the kinng pins, and noticed that the HWH jack
was leaking out of the screw that is at the top of jack. And had puddled in the
base of jack in 15-20 min. What is purpose of screw, do I just tighten it or is
there an o-ring behind it??? Anyone have any ideal?? Tenn.

[Tenn.Vol.]

Today I raised the MH to grease the kinng pins, and noticed that the HWH jack
was leaking out of the screw that is at the top of jack. And had puddled in the
base of jack in 15-20 min. What is purpose of screw, do I just tighten it or is
there an o-ring behind it??? Anyone have any ideal?? Tenn.

[troth]

Your best bet will be to start here (have your spec sheet handy):
HWH phone #:(800)321-3494

[zertrider]

That is not a screw, it is the jack up sensor. They have an O-ring on it to seal it. Retract the jacks completely, disconnect the wiring connector and take the sensor out and check the O-ring. If it cracked or pinched, replace it and screw it all back together, and your leak should be cured.

[Tenn.Vol.]

Oh but a little bit of knowledge,{zertrider} Thank for the heads up, dont know why
one needs to disconnect the wores, but I will! Thanks everyone for the effort.

I assume that if it is adjustment, I need to set it back to the same position.
So I willl count the number of turnes out?? TENN.

[zertrider]

There is no adjustment. It is screwed down and tightened against the seat. And remove the wire connection so as not to twist the wires too much.