Hi, I'm new to this forum.
Can you help me figure out how I can access the jam nuts on the back of the dump handle assemblies in the water compartment?
My grey water handle jam nut backed its way all the way off so the assembly is loose in the hole.
Thanks,
Mark
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Hi, I'm new to this forum.
Can you help me figure out how I can access the jam nuts on the back of the dump handle assemblies in the water compartment?
My grey water handle jam nut backed its way all the way off so the assembly is loose in the hole.
Thanks,
Mark
Best if you post a couple of photos so we can see exactly what you have. I am assuming that you have tried to screw it back in with no luck. If your panel looks like this then you will need to remove it to expose the blade valves assemblies. If you go to that much work than you might as well get a pair of the rebuild kits and refurbish them both. I can tell you more if you post photos or confirm that we have the same setup.
__________________
33' 2008 National Tropical on a Freightliner chassis.We tow a 2001 XJ (Cherokee) RVM#189
Linear Mode
