We lost ours for two different reasons on our 2016 Journey. Once the motor and once the control module. Yes, there is a way to hot wire the bed lift, but you will have to be careful not to raise it or lower it further than needed or you will strip the gears on the lift.
Call Lippert tech support. They will step you through the trouble shooting. It is a matter of reading the LED codes on the control module and using a multi meter. If it is the module you can hot wire it in an emergency. Replacing the module is a ten minute plug and play except for programming it which in a PITA. Again, Lippert we send you the instructions.
If you have lost the motor, be prepared to spend several hours replacing it. As they say, "some disassembly required."
Good luck! Contact me if you would like any more information.
__________________
2016 Winnebago Journey 40R - 2012 Jeep Rubicon
2 Arctic Cats, 3 Shelties, 4 cats
Bottle of Jack Daniels & wife
|