I had a 1”-1/2” crows foot and wrenched shipped to key west. Bushing was right.
When getting ready to leave, I had the wife hold the IN button, I noticed the front starting to lag and gave it a 230# push and over did it, so told her to go back out. It came back in but rear had barely a reveal and the front of slide had a larger reveal.
I have ordered a new motor from Newmar, but now I am concerned of how do I get the slide re-centered in opening.
Picture with ladder is rear of slide, it also bent out a little piece of painted plastic, I pulled it off to replace if I can get this slide centered. The cogs are good and the cog grooves are good. Is this something anyone has done, or should I plan a trip to Nappanee?