Community Forums

Logrady · 10-16-2013, 11:17 AM

After our last trip out it was time to winterize and wash and wax. I notice that the rubber part of the cb antenna was gone, just the base and 3 inch shaft was left. Is it a 2 part system or do I have to remove the base on the roof?

chuckinthebus · 10-16-2013, 11:26 AM

Picture would help, but you shouldn't have to remove from roof as replacement of upper part should be available. It was in my case.

Beacher · 10-16-2013, 03:20 PM

It's a two part piece nothing has to be removed from the roof. One Philips screw and that's it

"007" · 10-17-2013, 07:26 PM

I picked up the radio ant at Radio Shack came with a base but only the rubber ant needed and the new Phillips screw.

Logrady · 10-17-2013, 07:57 PM

will get up on the roof tomorrow when it stops raining. will know if its a cb antenna or the one for the sony surround sound, I know its was a rubber antenna

shaman52 · 10-20-2013, 08:28 AM

My MADP has two rubber antenna. One up front for the dash radio and one mid coach passenger side for the component stereo. Both are identical. The replacement I found was at O'Reilley Auto Parts and was a screw on 14" long rubber mast only unit with four different screw studs. Use red LockTite on threads to prevent re-occurrence of loss. Details as follows:

Metra Electronics - Antenna Mast
RUBBER MAST W 4 STUDS

Product Details

44-RM1R/AW-RM1R/CF-RM1R/CK-RM1R

REPLACEMENT MAST FOR UNIVERSAL APPLICATIONS FITS MOST GM FORD CHRYSLER AND VEHICLES WITH JAPANESE THREADS

14 INCH BLACK CONDUCTIVE RUBBER MAST ONLY

Good luck!

THERAPY GUY · 10-27-2013, 07:04 PM

I would like to build on this plz. I just bought a 2007 Dutch Star 4023 and it has 4 antennas on the roof. 2 over the drivers seat, 1 over the passenger seat and 1 in the rear over the bed room tv area. None of the antennas are there, just the screw type studs. Can anyone tell me what each stud is for and also are all replacement antennas alike or do I need to purchase replacements relative to the use of the specific stud? This forum has been very helpful on where to go for replacements I just need further clarification and direction. Thanks Gene
ps. I am sure one up front is for the AM/FM and another for the CB radio, but which?