Drivers side rear slide didn't completely close?

[DandyDon]

Had to get out of our site in Mesa yesterday and when we tried to put the drivers side rear slide in it did not close and seal at the bottom (maybe 1 inch gap). Because of that the slide lock didn't engage. My neighbor suggested it was probably out of alignment. Any ideas on what this is and how to correct it?The coach is being stored right now but this problem will need to be rectified.

[Fefanatic]

Is it a intellitech controlled slide? If so you need to find the control board and adjust the sensitivity.

[Dutch Star Don]

I would put it back out and thoroughly check that a slipper, dog toy or something else isn't under the slide.

[danleininger]

Sounds like a call to Newmar CS.

["007"]

Slide may be your bed slide correct?
This link will give you what might be going wrong, loose motor bolts, stop rod problems, etc,etc.
That link comes from this one.