Follow-up Question On Program Full Wall Slide Module

[Spiderwoman]

Quote:
Originally Posted by JMcG View Post
Try this YouTube video and see if it helps.

https://www.youtube.com/watch?v=scHiM7IjDAc

JMcG
2016 VTDP 3725
I finished watching the YouTube Video and GREAT HELP!!! THANK YOU!. I again disconnected the 12V power and will be getting ready to again try to reprogram correctly.

All 4 lights are currently flashing and the Full Slide is Retracted......

I noted at the beginning of the Video that it was strongly recommended to begin the Programming with the Slide in an Extend Position. Can I manually use the two Extend Buttons to extend the Slide before restarting the Programming from Step 1 in the Video. I have not tried to use the User Button inside the RV but assuming I will need to do the extend using the Program Module Buttons.

Any help is appreciated.

Thanks Again.
Spiderwoman is online now Report Post
Spiderwoman is offline Report Post Reply With Quote

[JMcG]

I wish I could give you a direct answer, but I can’t. You should be able to use the two extend buttons to move the slide out but if you do please ensure that your slide locks are not engaged. I would attempt to use the inside button to extend the slide first, but have someone on the outside observing while you are doing this to ensure the slide is opening equally from end to end. Sorry I could’ve have been more helpful.
JMcG
2016 VTDP 3725

[Spiderwoman]

Originally Posted by JMcG

I wish I could give you a direct answer, but I can’t. You should be able to use the two extend buttons to move the slide out but if you do please ensure that your slide locks are not engaged. I would attempt to use the inside button to extend the slide first, but have someone on the outside observing while you are doing this to ensure the slide is opening equally from end to end. Sorry I could’ve have been more helpful.
JMcG
2016 VTDP 3725

Just wanted to thank you again and update our status on the Full Wall Slide after all of your invaluable information.

The Slide is Programmed!! Your advice and the Video provided was just what we needed. We extended the Slide using the Extend Buttons on the Program Module. User Mode Button was not working. Reset the 12V power to the Module and followed the Step by Step Instructions. We are Set.