|
10-04-2017, 11:20 AM
|
#1
|
Member
Join Date: Jan 2013
Location: Indiana
Posts: 44
|
Lippert steps not working
Just bought a 2008 Grand Star 3750 from a dealer who has no knowledge of Class A's. Bought in as is condition. Have figured everything out but the steps will work 4-5 times and then quit. Any ideas? Took back to the dealer who said they worked on a power problem but back to doing the same thing now. These are Lippert steps.
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
10-04-2017, 11:30 AM
|
#2
|
Senior Member
Join Date: Jun 2012
Location: The Bluegrass State
Posts: 8,889
|
It could be:
Improper lubrication or ;lack of lubrication of the step linkages.
The magnetic door switch is out of alignment.
Poor ground connection (there can be several grounds)
Poor connection at the fuse holders.
Poor electrical connector. Corrosion, bad wire, broken, etc.
Inside switch is faulty.
Bent linkages.
Motor and/or gear box going bad.
__________________
Good Luck, Be Safe and Above All, Don't Forget To Have Fun
Pete
Central Kentucky
2006 Fleetwood Discovery 35H, 2014 Honda CR-V, M&G Engineering Braking System
|
|
|
10-04-2017, 11:51 AM
|
#3
|
Moderator Emeritus
Nor'easters Club Workhorse Chassis Owner iRV2 No Limits Club
Join Date: Oct 2004
Posts: 30,785
|
Welcome to the forum, Jake
As Pete mentioned lube is very important as also grounds to the chassis of coach.
Three ground locations one short green wire from control unit to controls mounting screw, one coming from the door switch to someplace on chassis frame near steps to frame or iron framing near step which will with time get corroded and needs attention to be cleaned up.
One other ground green heavy wire to chassis frame with much protector sealant and usually is not the problem.
Any time working under coach do not put body under stair area or run the risk of being crush by stairs.
In this link you will find information on the stairs.
Below in my signature are links to many more for info for your Newmar.
T http://www.irv2.com/forums/f103/tech...ch-313846.htmlhis link will lead you to TSB's, brochures, owners guides and other info for your coach, follow the directions.
|
|
|
10-04-2017, 11:51 AM
|
#4
|
Member
Join Date: Jan 2013
Location: Indiana
Posts: 44
|
Oh WOW what did we get ourselves into????
|
|
|
10-04-2017, 12:00 PM
|
#5
|
Moderator Emeritus
Nor'easters Club Workhorse Chassis Owner iRV2 No Limits Club
Join Date: Oct 2004
Posts: 30,785
|
You have the enjoyment of a Newmar but you need to know a few things about it, that's the fun of it, take your time and go through the information.
If you have access to 110 outlet plug coach in so the BIRD System can maintain your battery systems, check battery water levels and make sure your battery cut off switch is on so converter can charge the house batteries and chassis battery.
Enjoy and safe travels to come.
|
|
|
10-04-2017, 05:47 PM
|
#6
|
Member
Join Date: Jan 2013
Location: Indiana
Posts: 44
|
Checked the ground wires and they look good. Lubricated the steps and now they are working again. Hopefully this fixes the problem. Thanks everybody for the help.
|
|
|
10-04-2017, 06:16 PM
|
#7
|
Senior Member
Join Date: Jun 2012
Location: The Bluegrass State
Posts: 8,889
|
Quote:
Originally Posted by 007";3835414]
[FONT="Arial
Welcome to the forum, Jake
As Pete mentioned lube is very important as also grounds to the chassis of coach.
Three ground locations one short green wire from control unit to controls mounting screw, one coming from the door switch to someplace on chassis frame near steps to frame or iron framing near step which will with time get corroded and needs attention to be cleaned up.
One other ground green heavy wire to chassis frame with much protector sealant and usually is not the problem.[/FONT]
Any time working under coach do not put body under stair area or run the risk of being crush by stairs.
In this link you will find information on the stairs.
Below in my signature are links to many more for info for your Newmar.
T http://www.irv2.com/forums/f103/tech...ch-313846.htmlhis link will lead you to TSB's, brochures, owners guides and other info for your coach, follow the directions.
|
Excellent comment Double O Seven! Just the other day I was shimming under the steps area to spray lube into the joints and I said to myself "self, what you are doing is really a dumb thing. If these steps suddenly extend, you will probably lose that gut the hard way"
Also remember, if your hands and arms are entwined inside the step mechanism and the wind blows the door closed and the steps suddenly retract, you could get hurt also.
I've gotta remember to use that caution in any future comments about steps. THANKS!
__________________
Good Luck, Be Safe and Above All, Don't Forget To Have Fun
Pete
Central Kentucky
2006 Fleetwood Discovery 35H, 2014 Honda CR-V, M&G Engineering Braking System
|
|
|
10-06-2017, 11:18 AM
|
#8
|
Moderator Emeritus
Nor'easters Club Workhorse Chassis Owner iRV2 No Limits Club
Join Date: Oct 2004
Posts: 30,785
|
Thanks for your post of other highlights, Bigd9
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|